Dynex OPSYS MW 91000051 - Manual (Page 44)

Configuring the System
Specifying the Pump Parameters
The CAL. command allows the calibration values for each pump to be
specified:
1. Select SETUP (if needed). The display will read:
Select option
HEAD
PLATE
2. Scroll right to display the next selection:
Select option
VERSION CAL.
3. Select the pump pressure (high or low). The display will read:
Pump speed? 190
4. Enter the desired value using the keypad and press ENTER. The
display will read:
Slope? 2.1
Note: The Slope and Intercept values should
only be changed by
DYNEX Technologies
Service Personnel.
5. Press ENTER to keep the existing value. The display will read:
Intercept? 24
6. Press ENTER to keep the existing value. The display will again
read:
Select option
VERSION CAL.
Note: Refer to page 74 for additional pump
calibration instructions.
36 Opsys MW™ User’s Guide