Dynex OPSYS MW 91000051 - Manual (Page 37)

Configuring the System
Specifying the Wash Head
The HEAD command allows the installed wash head to be specified:
1. Select SETUP. The display will read:
Select option
HEAD
PLATE
2. Select HEAD. The current wash head selection is displayed in
the upper line:
Wash head? 8
8
If needed, scroll right to view the remaining selection:
Wash head? 8
12
3. Select the desired option using the function key. After the
selection is made, the display will again read:
Select option
HEAD
PLATE
Opsys MW™ User’s Guide 29