Delta JT360 User Manual
Page 10
10 - English
JOINTER TO STAND
Jointer weight is approximately 175 lbs.
Care must be taken when moving it. A
minimum of two people will be required to lift the ma-
chine.
1. Turn jointer upside down so it lays flat. One way to
do this is to place the jointer table onto two wooden
4x4s as shown in Fig. 9A.
2. Turn the stand upside down and align the threaded
holes in the bottom of the jointer with the holes in
the stand, two of which are shown at (A) Fig. 9B.
The infeed end of the jointer is fastened to the stand
through these two holes (A) Fig. 9B and (A) fig. 9C.
The outfeed end of the jointer is fastened to the stand
through hole (B) Fig. 9C.
A
Fig. 8
Fig. 9A
A
Fig. 9B
B
C
A
Fig. 9C
2. Remove M4x.7x10mm pan head screws, M4.1 flat
washers and M4x.7 hex nuts from two holes (A) Fig.
7 in switch.
3. Insert switch assembly (C) Fig. 7 from the inside of
the stand. Align the holes (A) in the switch with the
holes in the stand (A) Fig. 8.
4. Place a M4.1 flat washer onto a M4x.7x10mm pan
head screw. Insert screw through hole (A) in stand
and switch. Thread a M4x.7 hex nut onto screw.
Repeat this process for the remaining hole in stand
and switch.