CIRCUTOR MDC-4 - Manual (Page 23)

In the next steps, the level, hysteresis and connection and disconnection delays are pro-
grammed, as well as the status of the contactors for output relays 2, 3 and 4.
The programming is identical to that of sections 4�8�8, 4�8�9, 4�8�10, 4�8�11 and 4�8�12�
4.9.- PROGRAMMING THE CURRENT DATE AND TIME
The MDC-4 does not record the programming changes until all parameters have been pro-
grammed. If the unit is RESET before programming all parameters or no key is pressed for 60
seconds, the configuration will not be stored in the memory.
To enter the programming menu for the current date and time, hold the and key for 2
seconds; the main programming screen will be displayed.
SETUP DATE
Press the key to enter the first programming step.
4�9�1� Day
SET DAY
_8
In this step the day of the month is programmed.
Press the
button to increase the digit that is
currently flashing.
When the desired value is shown on the screen, move onto the next digit by pressing the key
to modify the remaining values.
Press key to access the next programming step.
4�9�2� Month
SET MONTH
04
In this step the current month is programmed.
Press the
button to increase the digit that is
currently flashing.
When the desired value is shown on the screen, move onto the next digit by pressing the key
to modify the remaining values.
Press key to access the next programming step.
23 Instruction Manual
MDC-4