CIRCUTOR CMBUS series - Manual (Page 18)

5�2�4� CMBUS START-UP
Once the slave units and their corresponding M-BUS memory maps have been determined,
and the Modbus parameters to which the converter must respond have been configured, click
the button “ Download config” to send the configuration to the transducer ( Figure 17 ).
Figure 17:Sending the configuration to the CMBUS
Once the configuration has been sent to the unit, the program will display the corresponding
information in the status bar ( Figure 18 ).
Figure 18: Sending of the configuration to CMBUS completed.
To verify the correct reception of the data obtained from the M-BUS slave units, click the TEST
button ( Figure 19 ). The values reported by the slave units will be shown in the table of Modbus
variables.
Figure 19: Verifying correct data reception with the TEST button
18
CMBUS
Instruction Manual