Dynex DX-L24-10A - Manual (Page 9)

TV components
5
DX-L24-10A
Installing a wall-mount bracket
If you want to attach the TV to a wall-mount bracket (not provided), you
should first remove the stand pedestal if it is pre-attached.
To remove the stand column:
1 Lay your TV face down on a table or bench. Make sure that you
put down a soft cushion or cloth so that your TV is not scratched.
2 Remove the four screws holding the stand column to your TV,
then remove the stand and the stand column.
Note: The appearance of this product in these illustrations may differ from
your actual product, and is for comparative purposes only.
To attach your TV to a wall-mount bracket:
Warning: These servicing instructions are for use by qualified service
personnel only. To reduce the risk of hazards, do not perform any
servicing other than that contained in the operating instructions
unless you are qualified to do so.
1 Remove the four screws holding the TV to its base, as described
above.
2 Secure the wall-mount bracket to the back of your TV using the
four M4*10 screws provided with the bracket.
TV components
Front
Remove four screws
# Component Description
1 Power indicator Lights blue when your TV is turned on.
Lights red when your TV is in standby mode.
Flashes blue when your TV receives no signal
from VGA and enters DPMS (Display Power
Management System) mode.
No lights when power cord is unplugged.
For more information, see “Turning your TV
on or off“on page 12.
2 Remote sensor Receives signals from the remote control. Do
not block.
DX-L24-10A_10-0348.book Page 5 Monday, March 22, 2010 4:26 PM