Dynex DX-L24-10A - Manual (Page 8)

4
Installing and removing the stand DX-L24-10A
3 Insert the stand column into the TV stand and secure it with the
stand column screws.
4 With the wider side of the stand facing down, align the tabs on
the stand column with the holes on the stand, then gently push
the stand toward the stand column until it clicks into place.
5 Secure the stand with the four stand screws.
Adjusting the viewing angle of the TV
To adjust the viewing angle:
• Adjust the angle forward up to 3° and backward up to 10°.
Caution: When adjusting the angle, use caution to avoid slipping or
tipping the TV.
Removing the stand
To remove the stand from the stand column:
1 Lay your TV face down on a table or bench. Make sure that you
put down a soft cushion or cloth so that your TV is not scratched).
2 Adjust the stand so that the angle between the stand and the TV
is 90°.
3 Remove the four stand screws, then press the two black tabs on
the bottom of the stand together and push them into the stand
column and pull the stand off the stand column.
Stand column
Stand groove
Screws
Wider side of stand
facing down.
Stand
Tab
Stand screws
Stand screw holes
(bottom view of
stand)
3 10
90
Stand screws
Tabs (bottom
view of stand)
DX-L24-10A_10-0348.book Page 4 Monday, March 22, 2010 4:26 PM