Directed Electronics HVM702A - Manual (Page 8)

B Baatttteerryy R Reeppllaacceem meenntt
1. Follow the instructions given in the illustration below to open the battery
holder.
2. Remove the old battery and replace it with a CR2025 or equivalent. The posi-
tive (+) side of the battery must be facing upward in the clip.
3. Push the battery holder into the body of the remote control until the battery
holder is locked.
4. Properly dispose of the old battery.
O Oppeerraattiioonn
P PO OW WE ER R O ON N//O OF FF F
1. Press any button on the LCD screen, or press the POWER button on the remote
control to turn the monitor on.
2. To turn power off to the LCD screen press and hold the power button (PWR) on
the LCD screen for 2-seconds, or press the POWER button on the remote con-
trol.
N NO OTTEE:: When using this monitor with a multiple A/V input selector (AV102); with
power on, momentarity press the power button on the LCD screen to select AV1 or AV2
signal source.
M MU UT TE E
Press the power on/off button on the monitor to mute the audio, press again to
restore the audio.
N NO OTTEE:: The power on/off button on the monitor does not mute the audio when there
is an A/V input selector (VS102), in which case the button selects the A/V input.
1
2
8 8
© 2004 Directed Electronics, Inc.