Directed Electronics HVM702A - Manual (Page 11)

H Heeaaddrreesstt H Hoouussiinngg//B Beezzeell IInnssttaallllaattiioonn
1. Remove the cover from the headrest.
2. Using the headrest housing as a template, posi-
tion the housing over the backside of the headrest
and mark the foam with a felt tip pen. Cut the
marked portion of foam and pull out the cut por-
tion.
3. Insert the headrest housing into the headrest
and secure the the headrest. Usually wire ties
attached to the headrest posts is sufficient.
N NO OTTEE:: Ensure that the UP arrow on the headrest housing
is pointing up.
4. Replace the cover over the headrest. Mark 1-
1/2” from the inside of the headrest housing and
cut the material away.
5. Optional Step: Glue the material to the inside of
the headrest housing. Take care not to use exces-
sive glue so that the headrest bezel is not glued to
the headrest housing.
N NO OTTEE:: Glue is not required if the material of the headrest
covering is of sufficient thickness to be tensioned by the
headrest bezel.
6. Insert the headrest bezel into the headrest
housing and secure the assembly using the provid-
ed hardware.
N NO OTTEE:: Ensure that the UP arrow on the headrest bezel is
pointing up.
© 2004 Directed Electronics, Inc.
1 11 1