Directed Electronics HVM702A User Manual

Page 12

Heeaaddrreesstt IInnssttaallllaattiioonn

1. Unplug the DIN cable from the monitor.

2. Connect the LCD screen’s 8-pin DIN plug into
the 8-pin DIN plug of the headrest.

OTTEE:: When assembling the cable, match the arrows at

each end of the connector.

OTTEE:: Feed and orient the connector assembly behind

the shroud mount in the lower right hand corner. You
may have to feed some of the DIN cable up into the
headrest to accomplish this positioning.

3. Position the monitor over the mounting shroud
and apply even pressure to each corner of the mon-
itor until the internal clips lock the monitor in
place.

OTTEE:: Do not press on the LCD screen as this will dam-

age the screen.

4. Tape the end of the DIN plug to prevent dam-
age to the pins. Then feed this cable from the hol-
low post of the headrest down through the seat
back and connect it to the cable from the DVD play-
er.

OTTEE:: Ensure the cable does not entangle or interfere

with the seat positioning/adjusting mechanism.

5-pin adapter

cable

8-pin main

DIN cable