BIXOLON SRP-500 - Manual (Page 15)

Rev. 1.08 - 15 -
SRP-500
3-1 Serial Interface (RS232C)
Switch Function ON OFF Default
1-1
Emulation Selection Refer to the following table
OFF
1-2 OFF
1-3 Auto cutter Enable Disable ON
1-4 Cartridge one cartridge two cartridges OFF
1-5 Density
*1)
Bold Normal OFF
1-6 Special Function
*2)
Enable Disable OFF
1-7 Near end sensor Enable Disable ON
1-8 Undefined OFF
DIP switch Setting 1 Function
Emulation 1-1 1-2
BXL/POS OFF OFF
STAR OFF ON
BXL/POS-KP
*3)
ON ON
Emulation Selection
Switch Function ON OFF Default
2-1 Data receive error
Print “?”
Ignore OFF
2-2 Reserved OFF
2-3 Hand Shaking DTR/DSR XON/XOFF OFF
2-4 Word length 7bit 8bit OFF
2-5 Parity check Enable Disable OFF
2-6 Parity selection EVEN ODD OFF
2-7
Baud rate selection Refer to the following table
OFF
2-8 OFF
DIP switch Setting 2 Function
Transmission 2-7 2-8
2400 baud ON ON
4800 baud OFF ON
9600 baud OFF OFF
19200 baud ON OFF
Baud Rate selection
*1) : It may use in dark area. (like a restaurant). But printing speed to be slow down.
*2) : Enable = Automatically print NV bit image #1 after cutting.
*3) : Kitchen Printer mode : A alarm is generated by printer after auto-cutting and
in paper-end error. (It needs buzzer accessory)