Srp-150 – BIXOLON SRP-150 User Manual
Page 42
Rev. 1.08
- 42 -
SRP-150
The following characters can be represented by the CODE128 barcode.
* SHIFT characters
In the code set A, the character right next to the SHIFT follows the process
of code set B. SHIFT character cannot be used in code set C.
* Code set selection character (CODE A, CODE B, CODE C).
This character converts the code set A, B, or C into following code set.
* Function character (FNC1, FNC2, FNC3, FNC4)
Using function characters depends on the application program.
Only FNC1 can be used in code set C.
② Special characters are defined as the combination of two characters,
“{“, and one
character. ACSII character
“{“ is defined as two consecutive transmissions of “{“.
Specific character
Transmit data
ASCII
HEX
DECIMAL
SHIFT
{S
7B,53
123,83
CODE A
{A
7B,41
123,65
CODE B
{B
7B,42
123,66
CODE C
{C
7B,43
123,67
FNC1
{1
7B,31
123,49
FNC2
{2
7B,32
123,50
FNC3
{3
7B,33
123,51
FNC4
{4
7B,34
123,52
“{“
{{
7B,7B
123,123
“No. 123456”
In this example, code B is used for
“No.” and the following numbers are printed
in code B.
GS k 73 10 123 66 78 111 46 123 67 12 34 56
* If there is no code selection character in front of the bar code data, the printer
will stop executing the command and the following data will be processed as
general data.
* If
“{“ and the following character does not correspond to the certain special
character, the printer will stop executing the command, the following data will
be processed as general data.
* Code selection character and the SHIFT character are not printed as HRI
characters.
* FUNCTION characters will be shown as spaces in HRI characters.
* Control characters (<00>H to <1F>H and <7F>H) will be shown as spaces in
HRI characters.
be secured.
(The empty space requirements are different depending on
barcode type.)