Dakota Digital 393050 - Manual (Page 4)

(Water Temp Cont.)
For LSx based engines, the use of the supplied 1/8”npt >
the water temp sensor simple. First, u
Then, simply remove the allen-head plug toward the rear of the passenger
and sensor in this location.
***Use extreme care when tightening this assembly into the engine
1/8” thread is slightly smaller than the
wrench is typically a sufficient amount
Allen plug
Push Buttons
The two push button switches supplied in the kit are not
momentary switch can be substituted or used in their place
speedometer calibration, initial set up
displays. One side of each switch connects t
switch wire attaching to ground. The switch installation is covered in greater detail within the instrument cluster
manual.
Momentary Switch #1
To SW1
on control box
he use of the supplied 1/8”npt > 12mm bushing and crush washer make installation of
First, using two wrenches (5/8” and ¾”), tighten the sen
plug toward the rear of the passenger’s side
care when tightening this assembly into the engine to avoid
slightly smaller than the diameter of the 12mm thread, hand tightening plus
a sufficient amount.
Sensor installed Sensor and harness installed
The two push button switches supplied in the kit are not proprietary to Dakota Digital, a
momentary switch can be substituted or used in their place if desired. These switches are used fo
speedometer calibration, initial set up and for accessing the Odometers along with several other message
switch connects to the appropriate location at the control
The switch installation is covered in greater detail within the instrument cluster
4510 W. 61
st
St. N., Sioux Falls SD 57107
Phone: (605) 332-6513 Fax: (605) 339-4106
www.dakotadigital.com
[email protected]
©Copyright 2010 Dakota Digital Inc.
Momentary Switch #1 Momentary Switch #2
To SW2
on control box
Connect to good
chassis ground or
control box GROUND
MAN#650311
12mm bushing and crush washer make installation of
tighten the sensor into the bushing.
head and install the bushing
to avoid breaking the bushing. The
and tightening plus ¼ turn with a
Sensor and harness installed
proprietary to Dakota Digital, any normally open
. These switches are used for
Odometers along with several other message
the control module, with the remaining
The switch installation is covered in greater detail within the instrument cluster
Momentary Switch #2
To SW2
on control box