AXING SKQ 4-01 - Manual (Page 11)

Operation Instructions SKQ 4-01
Chapter 3: Programming
12.09.11 © AXING AG • Swizzerland • Reserving change in design and type - We cannot be held liable for printing error 11
+ = FTA program selected, scrambled program selected but not opened at the head-end,
FTA – or CA – = program is not selected.
To save and exit select + marked program and press OK key.
When FTA time-sharing program (e.g. regional program) is selected to outgoing mux, you must select
also the original program (e.g. national programs) to same mux..
3.3 Other functions
3.3.1 Info
In main menu, select “SW Version Info” and press OK to display receiver and user interface version
numbers plus unit serial number info..
Most of the system set-up is done in Configuration Menu. Select “Configuration” and press OK to enter.
Below are all selectable options in Configuration menu.
You can select the audio language in two ways. Firstly you can select from preset languages selecting
“Audio Language” and using left and right arrow keys (Fig 2. no 4 or 5) to select the language name.
Secondly if your language is not among the preset languages you can freely write any 3-character
language name.
Use double arrow keys to select character position, which will be underlined.
and select needed character using up and down keys. Use double arrow keys to exit edit with no
character underlined.
Select “ALL” if all received languages will be transmitted to digital output.
In “LNB Control Mode” you can select Normal or Power OFF using left and right arrow keys.
In “Start-Up Video Display” menu there are options “MPEG2 SD Monitor” and “Modulator Menu”.
When MPEG-4 programs are received or scrambled channels are not descrambled (marked with +) at
the head-end, select “Modulator Menu”. Otherwise select “MPEG2 SD Monitor”.
NOTE!
Fig. 11: Channel List
Fig. 12: SW Version Info
Fig. 13: Selectable options in
configuration menu
NOTE!