AVUE G65-WB27N – High Speed Outdoor PTZ with 27X Zoom - Manual (Page 7)

5.OPERATING THE SPEED DOME
FIRMWARE V2.58
Protocol: VIDO B02
Dome Address: 001
Comm 9600,N,8,1
Initial Screen
After powering up, the camera will enter the
self-test mode and display the status screen(
as in the picture left).It contains information
about the model and current settings.
- V2.58:
- Protocol:
- Dome address:
- Comm 9600,N,8,1:
Current firmware version
control protocol which currently used
Address ID of speed dome. please refer to the section "Protocol
setup " for details.
current setting of the serial communication interface.
Baud rate. please refer to section "Baud-Rate setup" for details
No parity bit, 8 bit length, 1 stop bit. this setting can not be changed
9600:
N, 8, 1:
Operation Screen
The intial screen will stay remain on until any user action is being taken. If the power-
up action is set, the initial info wil vanish immediatly.
32.0 CAM TITLE
ZONE-1
285 78 18X
Pan degree
Zoom factor
Tilt degree
Zone description
Temperature
4.INSTALLATION
Optional bracket accessories
The G65 and G70 Series can be equipped with various bracket accessories for indoor
and outdoor installation. please contact your distributor for further details.
Corner
Mount Pole
Mount Wall mount and
Power box
Ceilling
mount Indoor Wall
mount Outdoor
Power Box
Indoor ceilling
mount Extended wall
mount Swan-Neck
Mounting
bracket Wall
mount
Installing the core unit to base board.
The G65 and G70 Series core unit and base board are packed seperatly, in order to be
protected through the transportation. After unpaking and during the installation, the
core unit should be installed as following:
Installing the core unit by
pushing into the
housing.please note the
position of connector. For
releasing, please press the
lever-lock to core and pull off
the unit.
Lever-
Lock
Connector
Interface
Power
LED
Metal
Clip
WARNING:
Do not pull or hold the connector interface with force. It
is design only to connect the core unit and the base
board. Any presure on connector will cause damage and
avoids the warranty.
PTZ operation
For the surveillance operation, the dome can be controlled from a keyboard device
(e.g. AU-KB3N), Multiplexer or DVR through RS-485 Interface. Make sure that the
cable is connected and the settings (baud rate, Address ID and protocol) of both
keyboard and the dome are configured correctly. For more description about the PTZ
operation, please refer to the user’s manual of the keyboard.
Safety spring
Rubber ring
cable Heater connector
Once the base board is connected to power,
the power LED will light.
Heater connector
on outdoor
housing
Outdoor
housing cover
Screws
Some products may not be available in your country, please contact our distributor for more details Some products may not be available in your country, please contact our distributor for more details
9 10
Indoor
embedded
mount
ENGLISH
The operation screen can display additional
information.
Temperature: current temperature inside the
speed dome( °C)
Cam title: User definable camera title
Zone: Current zone name
Pan deg.: Pan angle, 0-359°
Tilt deg.: Tilt angle, 0-90°
Zoom Factor: Zoom factor
Display of the information can be activate or
deactivate through the OSD menu. please refer to
the system setting for detais.