DirecTV H10 - Manual (Page 74)

Other Information
70
Perform a Code Search on Your Remote Control
If you were not able to find a code for your brand of TV or component, then you can try a
code search. This process may take up to 30 minutes.
1) First turn on the TV or component.
2) Move the slide switch near the top of the remote control to the appropriate position.
3) Point the remote away from your DIRECTV
® HD Receiver and components. Press and
hold MUTE and SELECT buttons at the same time until the light above the Mode
Switch at the top of the remote flashes twice (about 5 seconds).
4) Enter one of the following 4 digits
TV: 9 9 1 1
VCR or DVD: 9 9 1 2
Stereo:
9 9 1 3
5) Press the PWR key on the remote control.
6) Point the remote to the TV or component and press CHAN UP. Repeatedly press the
CHAN UP until the TV or component turns off.
7) When the TV or component turns off, the press SELECT.
Note: If the light flashes 3 times before the TV or component responds, then you’ve cycled
all codes and, unfortunately, the code you need is not available. You must then use the
remote that came with your TV or component.
Perform a Code Search