Configure the drive for your motor and application – Applied Motion SV7-Q-EE User Manual
Page 11
6/26/2010
920‐0032a3 eSCL Communication Reference Manual
Page 11
6. Select the option “Use the following IP address”. Then enter the address “10.10.10.11”. This will give
your PC an IP address that is on the same subnet as the drive. Windows will know to direct any traffic
intended for the drive’s IP address to this interface card.
7. Next, enter the subnet mask as “255.255.255.0”. Be sure to leave “Default gateway” blank. This will
prevent your PC from looking for a router on this subnet.
8. Because you are connected directly to the drive, anytime the drive is not powered on your PC will
annoy you with a small message bubble in the corner of your screen saying “The network cable is
unplugged.”
Configure the Drive for Your Motor and Application
Three Windows programs are available from Applied Motion Products for use with our Ethernet drives. These
programs are included on the CD that accompanies each drive and the most recent version is always available
at
.