ABUS Technologies Log Box-RHT with LCD Data Logger - Manual (Page 12)

ABUS TECHNOLOGIES INC.
12
Log Box-RHT
Readings: Presents a series of parameters that define how
measurements will be.
Interval between readings: Defines the interval between readings: Minimum
interval is 1 (one) second.
Note: When the type of value logged is mean, maximum and minimum values, the
minimum interval is 10 seconds.
Daily repetitions: The user defines the time that daily logs will take
place.
Estimated time: In this parameter, the logger informs the user how
long it will take to occupy the full memory, in the
conditions set up during configuration.
Start of Readings: Readings can be started in one of five different
modes:
Immediately: It starts as soon as programming is considered to
be ready, and is then sent (OK) to the logger.
Start via Palm: It starts with a command sent via Palmtop, which
runs the software Log Chart Palm-OS.
Date: Readings start at predefined date and time.
Through Start Button: It starts and interrupts readings by pressuring the
Start button, in the frontal part of the logger, for
two seconds.
Setpoint: Measurements start when a temperature setpoint
is reached. In this option, the setpoint value is
defined in the Channels field, where the Alarm
parameter is replaced by setpoint.
End of readings: Options for the end of readings are:
Full Memory: Readings can be stored up to the full memory
capacity is reached.
Wrap around: Readings are continuous, replacing old registers
by new ones as the number of readings overpass
the memory capacity.