ABUS Technologies TAGTEMP Data Logger - Manual (Page 4)

ABUS TECHNOLOGIES INC.
4
TagTemp
1. INTRODUCTION
TagTemp is a small portable electronic temperature logger. Its internal sensor
measures local environment temperature and logs such values in an electronic
memory. Logged data, or ACQUISITIONS, can be later viewed and analyzed on a PC
where they can be opened in tabular and graph forms.
The logger is supplied with LogChart-II software, which enables to set up the
logger operation mode. It is also used for viewing acquisitions. Other parameters such
as end of measurements, logging interval, etc., are easily defined through the
LogChart-II software.
Acquisitions can also be exported to be analyzed in other applications, such as
spreadsheet programs.
2. PRESENTATION
2.1 Technical Parameters
Measuring Range : Temperature: -20 °C ~ 70 °C.
Accuracy : ± 0.5 °C @ 25 °C.
± 2 °C max. along the entire measured range.
Note: A measurement error can be fixed using the OFFSET parameter in the LOGCHART-II software.
Measurement Resolutions : 0.1 °C.
Memory capacity : 16,000 or 16k logs.
Measurement Resolution : 1 second min.
18 hours max.
Supply : 3.6 V lithium battery (CR2032), built-in.
Estimated Autonomy : Higher than 365 days, with weekly data reading. Frequent
logged data readings may shorten battery life.
Operating temperature : From –20°C to 70°C.
Protection : IP67
Material : Polycarbonate
Dimensions : 30 x 47 x 0.47 mm
Logger-PC Data Rate : 40 seconds for 16,000 logs.
PC Interface : IR/USB Port or IR/Serial Port
Log-chart-II software requirement : Setup Software for Windows 95, 98, NT, 2000 and XP,
Menus in Portuguese, English, and Spanish.
Setup, reads and displays data on the screen.