ABUS Technologies RHT WM with LCD Датчики - Manual (Page 9)

ABUS TECHNOLOGIES INC.
9
RHT
6. INSTALLATION
Recommendation
 Conductors of small electrical signals must be distant from activation or high-
tension/current conductors, preferably passing through grounded conduits.
 A specific electrical power supply network should be provided for instruments use
only.
 In controlling and monitoring applications, possible consequences of any system
failure must be considered in advance.
 RC filters (47 R and 100 nF, serial) in inductor charges (contactors, solenoids, etc.)
are recommended.
7. CONFIGURATION
If the default configuration or the ordered configuration satisfies the application,
then no further configuration is necessary and the transmitter is ready to be used. If a
new setting is desired, this can be accomplished by the ATxConfig and sent to the
transmitter through the ATxConfig interface.
The ATxConfig Interface and Software compose the Transmitter Configuration
Kit, which can be purchased separately from ABUS or one of its distributors. The latest
release of this software can be downloaded from our web site. To install, run the
ATx_setup.exe and follow the instructions.
Serial port configuration errors may occur when other software are sharing the
same serial port. Close all serial port applications prior to using the ATxConfig
software.
The ATxConfig interface cable is 1.5m long. One extremity is connected to the
transmitter. The other extremity has a female connector DB9, which must be
connected to the serial port available in the PC.
Loop Powered or Power Supply 9 Vdc Battery Power
Connections of the ATxConfig Interface