Dynex DX-32L130A10 - Manual (Page 22)

Maintenance
19
DX-32L130A10
Notes:
If the problem is not solved by using these troubleshooting
instructions, turn off your TV, then turn it on again.
Contact us by logging on to www.dynexproducts.com or by
calling DYNEX Customer Service at (800) 304-2204 (USA
and Canada only).
Maintenance
Just like with any other household appliance, the
performance and life- expectancy of your TV
depends on how well you maintain it. Follow the
procedures described here to clean the TV case and
the LCD screen.
Cautions:
• Make sure that the TV is turned off and the power
cord is disconnected from the power outlet before
cleaning the TV.
• Never spray or pour any liquid directly onto the
screen or the case.
Cleaning
• Clean your TV with a soft, dry cloth. If surfaces
are extremely dirty, use a soft cloth dampened
with a small amount of non-ammonia,
non-alcohol-based, mild, non-abrasive
detergent.
• Clean the screen with a clean, soft, lint-free
cloth. If additional cleaning is necessary, apply a
small amount of non-ammonia,
non-alcohol-based glass cleaner onto a clean,
soft, lint-free cloth, then wipe the screen.
Specifications
Design and specifications are subject to change
without notice.
Dimensions and weight are approximate.
Legal notices
FCC Part 15
This device complies with Part 15 of the FCC Rules.
Operation of this product is subject to the following
two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept
any interference received, including interference
that may cause undesired operation.
This equipment has been tested and found to
comply within the limits for a class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However,
there is no guarantee that interference will not occur
in a particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to try
to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced technician
for help.
You cannot access
some items • If a setting or option is grayed out, it is not
available in the current input mode.
The TV cabinet
creaks • When you are using your TV, the
temperature inside the cabinet increases.
This causes the cabinet to expand or
contract, causing the creaking noise. This is
not a malfunction.
The buttons do not
work • Unplug the power cord for a few seconds,
then plug it back in and turn on your TV.
TV model DX-32L130A10
TV type LCD
TV panel 31.5-inch TFT LCD
TV system NTSC-M, ATSC
Problem Solution Channels VHF: 2-13
UHF:-14-69
CATV: 1-125
CADTV: 1-135
DTV: 2-69
Audio multiplex BTSC system
Audio output 6 w x 2
Power
requirement
AC 120 V~60 Hz
Power
consumption
117 W
Dimensions 40 x 8.7 x 25.7 inches (100.5 x 22 x 65.3 cm)
Weight 35.3 lbs. (16 kg)
Audio/video
input
terminals
Composite video/left and right audio (1)
S-Video (1)
Component video/left and right audio (2)
HDMI (2)
VGA/audio (1)
ANT/CABLE in (1)
Audio/video
output
terminals
Left and right audio
Headphone jack (1)
Digital coaxial audio (1)
DX-L32L130A10_09-0617_MAN_ENG_V1.book Page 19 Thursday, July 30, 2009 2:41 PM