Connecting a vcr, Making connections – Dynex DX-32L130A10 User Manual

Page 12

Making connections

DX-32L130A10

Connecting an antenna, cable TV, or
satellite TV box

Important: The antenna connector should only be

finger-tightened. Do not tighten this connector with any
tool, or you may damage your TV.

To connect an antenna, cable TV, or satellite TV box:

1 Turn off the TV before connecting the antenna.

2 Connect one end of a coaxial cable (not

included) to the RF OUT jack on the antenna or
on the cable or satellite TV box. If you are using
an antenna with twin-lead cable, you may need
a 300-75 ohm adapter (not provided) to
connect it to the back of your TV. Likewise, if
you are using several antennas, you may need a
combiner (not provided).

3 Connect the other end of the cable to the

ANT/CABLE IN jack on the side of your TV.

Notes:

Use a coaxial cable to eliminate interference and noise from

radio waves.

Do not bundle the coaxial cable with the power cord or other

cables.

If the antenna is not installed correctly, contact qualified

service personnel to correct the problem.

Connecting a VCR

To connect a VCR:

1 Make sure that your TV’s power cord is

unplugged and the VCR is turned off.

2 Connect an AV cable to the AV VIDEO and

AUDIO out jacks on the VCR.

Home antenna
terminal (75 ohm)

ANT/CABLE IN jack (on
the side of the TV)

Twin-lead flat cable

RF coaxial cable (75 ohm)

Twin-lead flat cable

Combiner (not provided)

300-75 ohm Adapter
(not provided)

VHF antenna

UHF antenna

VHF, UHF, or
combination
antenna

HEADPHONE

VIC

Antenna, cable
TV, or satellite box

Side of TV

VIDEO

S-

EO H

DPHONE

SER

Side of TV

AV cable

Note: Cables are often
color-coded to connectors.
Connect yellow to yellow,
red to red, and white to
white. Cables may be
separate or combined.

DX-L32L130A10_09-0617_MAN_ENG_V1.book Page 9 Thursday, July 30, 2009 2:41 PM