Dynex DX-32L130A10 - Manual (Page 16)

Turning on your TV for the first time
13
DX-32L130A10
Turning on your TV for the first
time
To configure your TV:
1 Make sure that you have inserted the batteries
in the remote control, connected the antenna,
cable, or cable box to the TV, and connected the
AC power.
2 Press POWER, then wait several seconds. The
initial setup screen opens (only the first time
you turn on your TV) and guides you through
setting up your TV’s operational settings.
3 Press ENTER. The setup wizard starts with the
Language screen.
4 Press or to select the language you want,
then press ENTER. The Tuner screen opens.
5 Press or to select Antenna or Cable, then
press ENTER. The Channel Scan screen opens.
6 Press or to select Scan, then press ENTER.
The channel scan begins.
Note: Channel scan is not necessary if you are using a
satellite or cable box.
Understanding the basics
Turning your TV on or off
To turn your TV on or off (standby mode):
1 Plug the power cord into an AC power outlet.
2 Press POWER. Your TV turns on.
3 Press POWER again to turn off your TV. When
you turn off your TV, it goes into standby mode.
Warning: When your TV is in standby mode, it is still receiving
power. To completely disconnect power, unplug the power
cord.
Note: If your TV does not receive an input signal for several
minutes, it automatically goes into standby mode.
Selecting the video input source
The first time you turn on your TV, you must select
the TV signal source. Your TV stores this information,
so you do not need to change the TV signal source
unless it changes. For example, you change from an
outside antenna to cable TV.
To select the video input source:
1 Turn on your TV, then press INPUT on the
remote or on the TV. The INPUT SOURCE menu
opens.
2 Press or to highlight the video source, then
press ENTER.
DX-L32L130A10_09-0617_MAN_ENG_V1.book Page 13 Thursday, July 30, 2009 2:41 PM