Denon DHT-M330DV - Manual (Page 35)

35
ENGLISH
[2] 2-channel mode settings
• In the AUTO DECODE mode, it is possible to automatically conduct multi-channel playback in the Dolby Digital or DTS surround mode or play
in the stereo 2-channel mode (AUTO STEREO mode: factory default setting). For 2-channel input signals, one of four play modes can be set
with the 2-channel mode setting (Auto Stereo, Dolby Pro Logic II Cinema, Dolby Pro Logic II Music and Dolby Pro Logic II Game).
For analog and PCM sources, it is also possible to select DTS NEO:6 Cinema and DTS NEO:6 Music.
When the function is set to TAPE or TUNER, the “Auto Stereo” 2-channel mode cannot be selected. To play in stereo, set the
surround mode to “STEREO” (page 29).
NOTES:
• The 2-channel decode mode cannot be set when Dolby Digital
5.1-channel signals or DTS signals are being input.
Once the surround parameters have been set, stop operating
buttons. After several seconds the display returns to normal and
the settings are automatically validated.
1
2
3 3
1 2 3
1 Set the surround mode to “AUTO DECODE”.
•“AUTO DECODE” is displayed, then the normal display
reappears.
Remote control unit Main unit
or
If the mode is set to anything other than AUTO DECODE,
the AUTO DECODE mode can be set using the AUTO
DECODE button on the remote control unit.
2 Press the SURROUND PARAMETER button on the remote
control unit and select the 2-channel decode mode.
Remote control unit
< U A T O S T >
Main unit
This can be selected when the digital input consists of no
signal, PCM signals, Dolby Digital 2-channel signals, as
well as when the analog input is selected.
3 Select the desired 2-channel decode mode using the ( and
) SELECT buttons.
• The mode switches as follows each time one of the buttons
is pressed:
Remote control unit
DTS NEO:6C and DTS NEO:6M can be selected for analog
and PCM sources.
The Auto Stereo mode can be selected when the function
is set to DVD, TV/AUX1 or AUX2.
AUTO ST
DTS Neo:6M DTS Neo:6C
PL C PL M
PL G
Set the remote
control selector
switches
Switch1 to DVD
Switch2 to AMP
Main unit
• Operate the remote control unit at the “AMP” position.