Cleaning the wheels, Fitting a wheel, The "fitting a wheel" section – Mercedes-Benz 2013 GLS Class User Manual
Page 384: Wheels and tyres, Changing a wheel

Cleaning the wheels
G
WARNING
The water jet of circular-jet nozzles (dirt grind-
ers) can cause damage not visible from the
outside to tyres or chassis components. Com-
ponents damaged in this way can unexpect-
edly fail. There is a risk of an accident.
Do not use high-pressure cleaners with circu-
lar-jet nozzles to clean the vehicle. Have dam-
aged tyres or chassis components replaced
immediately.
Fitting a wheel
Preparing the vehicle
X
Stop the vehicle on solid, non-slippery and
level ground.
X
Apply the parking brake.
X
Bring the front wheels into the straight-
ahead position.
X
Shift the transmission to position
P.
X
Vehicles with AIRMATIC: make sure that
"normal" level is selected (
X
Switch off the engine.
X
Vehicles without KEYLESS-GO: remove
the key from the ignition lock.
X
Vehicles with KEYLESS-GO: open the
driver's door.
The on-board electronics now have status
0. This is the same as the key having been
removed.
X
Vehicles with KEYLESS-GO: remove the
Start/Stop button from the ignition lock
(
X
If included in the vehicle equipment,
remove the tyre-change tool kit from the
vehicle (
X
Secure the vehicle to prevent it from rolling
away.
i
Apart from some country-specific var-
iants, vehicles are not equipped with tyre-
changing tools. Some tools for changing a
wheel are specific to the vehicle. For more
information on which tools are required to
perform a wheel change on your vehicle,
consult a qualified specialist workshop.
Necessary wheel-changing tools can
include, for example:
R
jack
R
wheel chock
R
wheel wrench
Securing the vehicle against rolling
away
If your vehicle is equipped with a wheel chock,
it can be found in the tyre-change tool kit
(
The folding wheel chock is an additional
securing measure to prevent the vehicle from
rolling away, for example when changing a
wheel.
X
Fold both plates upwards :.
X
Fold out lower plate ;.
X
Guide the lugs on the lower plate fully into
the openings in base plate =.
382
Changing a wheel
Wheels and tyres