Lenco CR-3306 BT - Manual (Page 9)

9
Adjust the brightness of the display
When the device is in standby mode, press the Dimmer button (1) to adjust the display
brightness. The brightness can be set to low, medium and high.
Basic Operation
Basic Features
Power on/off the device,
press the Power button (13) to turn the device on or off.
Adjust the speaker volume,
press the volume buttons (8, 9) to adjust the volume.
Select the input source,
press the de source button (13) to select the input source, the
options are: Radio, AUX and Bluetooth®.
Setting the alarm clock
The device is equipped with 2 independent alarms, which can be set to wake you at
different times. When the alarm sounds, it will start soft and it will gradually increase in
volume until the maximum set volume is reached. Set the alarm as follows:
Important note
: If both alarms are set within 60 minutes of each other, the first alarm
will automatically be disabled when the second alarm is scheduled to start. The alarm
that is disabled will sound again at the set time on the next day.
Note
: in the instructions below, alarm 1 is set as an example. Alarm 2 can be set by
following the same procedure.
1. Make sure the device is in standby mode.
2. Press the Alarm 1 button (19), the Alarm 1 LED (5) lights up.
3. Press the Alarm 1 button (19) again and keep it pressed until the hours starts
flashing.
4. Use the Previous (12) and Next (10) buttons to set the hours.
5. Confirm the hours by pressing the Alarm 1 button (19).
6. Once the hours have been confirmed, the minutes start flashing.
7. Use the Previous (12) and Next (10) buttons to set the minutes.
8. Confirm the minutes by pressing the Alarm 1 button (19).
9. Once the minutes have been confirmed, the wake up source starts flashing.
10. Use the Previous (12) and Next (10) buttons to select the wake up source. The
following sources can be selected: FM and ALARM. When setting the source,
please note that beeping sound will play when selecting Alarm and the right radio
station is selected when selecting FM.