Lenco CR-3306 BT - Manual (Page 10)

10
11. Confirm the wake up source by pressing the Alarm 1 button (19).
12. Finally set the desired maximum wake up volume. Use the Previous (12) and Next
(10) buttons to set the wake up volume.
When the alarm sounds, the alarm will sound 60 minutes. After 60 minutes, the alarm
stops and it will sound again on the next day.
Snooze, interrupt the alarm
When the alarm sounds, it can be temporarily interrupted. Interrupt the alarm by
pressing the Snooze button (1). When snooze is activated, the alarm will resume after
9 minutes. Using the snooze function is possible for up to 60 minutes after the set
alarm time. After 60 minutes, the alarm stops and it will sound again on the next day.
Disable the alarm for 24 hours
If you want the alarm to stop and continue on the next day, press the Power button
(13).
Disable the alarm
Press the Alarm 1 button (19) to disable alarm 1. Press the Alarm 2 button (18) to
disable alarm 2.
Radio mode
This device has an FM radio with a wire antenna for receiving radio signals. If you want
to listen to the radio, first fully extend the wire antenna. If the signal is weak, adjust the
position of the antenna to find the best reception. Contact your local service provider
for a frequency list of the radio stations that can be received in your area.
Turning the radio on
Press the Power button (13) to turn the device on. If the radio is not in radio mode,
press source (13) until the display shows "Rad". Once "Rad" has disappeared, the
frequency and the band (FM) are shown on the display.
Finding a station / frequency
You can use manual tuning or automatic tuning when searching for a radio station. To
automatically search for a station with a frequency higher than the current frequency,
hold the next button (10) for 3 seconds. To automatically search for a station with a
frequency lower than the current frequency, hold the previous button (12) for 3 seconds.
Once the tuner has found a station with sufficient signal strength, it will stop scanning
automatically.
To manually switch frequency or to fine tune, briefly press the previous button (12) to
lower the frequency with steps of 0,05 MHz. Briefly press the next button (10) to
increase the frequency with steps of 0,05 MHz.
Storing preset stations
You can store up to 10 stations in the memory. Storing a station: