Lenco CR-3306 BT - Manual (Page 11)

11
1. Press the Preset button (17) and keep it pressed until CH starts flashing. CH is the
number of the preset station, which means the number that the station will be
saved under.
2. You can browse through the CH numbers by pressing the previous button (12) or
next button (10).
3. Store a station by pressing the preset button (17).
Recalling a preset station
You can recall a preset station by pressing preset (17). Then use the Previous (12) or
Next (10) button to browse through the stored stations.
Playback from a Bluetooth® device
Through the built-in Bluetooth® receiver, music can be wirelessly streamed from an
external Bluetooth® device to the Lenco radio. Enter the Bluetooth® mode by pressing
the source button (13) until BLUE is shown on the display . The radio will automatically
try to connect to the last paired device. If pairing fails or if you want to connect to a
different Bluetooth® device, hold the pair button (11) until the the Bluetooth® LED
starts flashing. See chapter "pair & play" for instructions on how to pair a Bluetooth®
device.
Basic Operation during playback from a Bluetooth® device
Depending on the external Bluetooth® device, the following functions might not
work, not work correctly or work differently than described.
Pause playback, press the play / pause button (11) during playback to pause playback.
Press the play / pause button (11) again to resume playback.
Skip to next track, press the next button (10) during playback to skip to the next track.
Skip to previous track, press the previous button (12) during playback to skip to the
previous track.
Other functions
Using the sleep timer
This device is equipped with a sleep timer that can be used to turn off the device after
a preset amount of time has elapsed. This is useful, for example when you want to fall
asleep while listening to music. To activate the sleep timer press the Snooze / Dimmer
button (1) when the device is turned on. Once you have pressed the button, the time
in minutes will appear on the display, the time can be adjusted by repeatedly pressing
the Snooze / Dimmer button (1). The sleep timer can be set to 90, 80, 70, 60, 50, 40,
30, 20, 10 minutes. Once the desired time is shown on the display, wait 5 seconds for
the device to store the time and activate the sleep timer. To disable the sleep timer,
press the Snooze / Dimmer button (1) and keep it pressed until OFF appears on the
display. It is also possible to turn the device off while using the sleep timer by pressing
the Standby/Source button (13).