Naim Audio NAC-N 172 XS - Manual (Page 5)

3
NAC-N 172 XS Installation and Connection
2.2 Mains Power Connection
Connect the NAC-N 172 XS to a mains power socket using
either the mains cable supplied or a Naim Power-Line.
2.3 FM/DAB Aerial Connection
The optional NAC-N 172 XS FM/DAB module will only be
able to provide high quality FM and DAB radio if a strong,
interference-free radio signal is available. The
NAC-N 172 XS rear panel FM/DAB Aerial socket must
be connected, via 75 Ohm low-loss coaxial cable, to a
suitable aerial. The aerial should be mounted clear of large
obstructions and as high as possible; ideally on a roof.
Note: Your local retailer should be able to offer advice on
a suitable aerial and aerial installer.
2.4 Audio Inputs and Outputs
2.4.1 Audio Signal Inputs
The NAC-N 172 XS provides three stereo analogue inputs
and five S/PDIF digital inputs including one combined
analogue/digital input socket. Connection to the inputs is
made via a variety of socket types. The following table lists
the inputs and their socket type:
Input Type Socket
an. 1 Analogue 5-pin DIN
an. 2 Analogue RCA phonos
front panel Analogue 3.5mm jack
Digital 3.5mm mini-TosLink jack
dig. 1 Digital Coaxial (RCA phono)
dig. 2 Digital Optical (TosLink)
dig. 3 Digital Coaxial (RCA phono)
dig. 4 Digital Optical (TosLink)
Note: The front panel analogue/digital jack socket can
accept both conventional analogue 3.5mm plugs and
mini-TosLink optical digital plugs. It will automatically
identify the type of plug inserted and handle the signal
appropriately.
Always use high quality interconnect cables to connect
sources to NAC-N 172 XS inputs.
2 NAC-N 172 XS Installation and Connection
Your NAC-N 172 XS should be installed on an equipment stand intended for the
purpose. Ensure it is well ventilated, and do not stand it directly on top of another item of
equipment. It should be installed in its final location before connecting cables or switching
on. The NAC-N 172 XS has no standby mode and is intended to be left switched on.
Connecting the NAC-N 172 XS to mains power and to a variety of audio peripherals and
sources is described in the following paragraphs. Diagram 2.1 illustrates the NAC-N 172 XS
rear panel connection sockets.
2.1 NAC-N 172 XS Rear Panel
mains input
and fuse
network
socket
power
switch line output preamp output
wireless network
(Wi-Fi) antenna socket
signal ground
switch
DAB/FM aerial
socket (optional)
digital
inputs
analogue
inputs
preamp
output
USB
upgrade
interface
remote in
and out