Nexen TCC-10 835141 - Manual (Page 13)

10 FORM NO. L-20069-E-0210
PARTS REPLACEMENT continued
REFER TO FIGURE 17.
1. Stop the machine and shut off the air supply to the
Tension Control Clutch.
2. Remove the Tension Control Clutch.
NOTE
To remove the Q.D. bushing, remove the Cap
Screws; then, reinsert them into the threaded
holes and tighten them to push the Rotor off
the Q.D. bushing.
FIGURE 17
Hub
(Item 30)
Bearing
(Item 23)
Retaining
Ring
(Item 25)
Retaining
Ring
(Item 24)
Retaining Ring
(Item 25)
Housing
(Item 8)
BEARINGS REPLACEMENT
Bearing
(Item 23)
3. Remove all the caliper assemblies and air lines from
the housing assembly.
4. Remove the Retaining Ring (Item 24) from the Hub
(Item 30).
5. Fully support the Housing (Item 8), then press the
Hub (Item 30) out of the Bearings (Item 23).
6. Use a bearing puller to remove the Bearings (Item
23) from the Housing (Item 8).
7. Clean the bore of the Housing (Item 8) with fresh
safety solvent. Make sure that all of the old Loctite®
residue is removed.
8. Apply Loctite ® 680, or equivalent, to the outer race
of the new bearing and press the bearings into the
Housing.
NOTE
Carefully align the bearing O.D. with the Housing
bore when you install the bearings.
9. Support the bearing inner race then press the Hub
(Item 30) into the Housing (Item 8).
10. Reinsert the Retaining Ring (Item 24).
11. Reinstall the Tension Control Clutch
CAUTION