Nexen TCC-10 835141 - Manual (Page 12)

9 FORM NO. L-20069-E-0210
AIRLINE REPLACEMENT
REFER TO FIGURE 15.
1. To disconnect an air line, first push the fitting collar in
and then pull the air line out.
2. To install a new air line, push the air line into the
fitting until it stops.
Push in the push-lock
collar and it will release
the air line
FIGURE 15
FIGURE 16
PARTS REPLACEMENT continued
Cylinder
(Item 11)
Diaphragm
(Item 14) Cover
(Item 13)
Cap
Screw
(Item 20)
REFER TO FIGURE 16.
1. Disconnect the air line.
2. Remove the Socket Head Cap Screws (Item 18) and
Lock Washers (Item 19).
3. Remove the Caliper Assembly from the Housing.
4. Remove six Cap Screws (Item 20) and the Cover
(Item 13) from the Cylinder (Item 11).
5. Remove the Diaphragm (Item 14).
NOTE
Internal Compression Springs (Item 41) may
also be removed at this time. These springs are
optional; the low air pressure setting is more
sensitive without the springs.
6. Reinsert the new Diaphragm (Item 14) and
reassemble the Caliper.
7. Tighten the Cap Screw (Item 40) to 22 ft-lbs [29.6
Nm] and the Cap Screw (Item 20) to 5.5 ft-lbs [7.4
Nm] torque.
Compression
Spring
(Item 41)
Cap
Screw
(Item 40)
DIAPHRAGM REPLACEMENT