Dakota Digital LAT-NR162 - Manual (Page 2)

MAN#650160
6. Remove the screw and aluminum back plate from the new LED assembly. The center hole in
the ’67 Caprice is smaller and offset so there is a special back plate supplied for this
application.
LED assembly Standard back plate ’67 Caprice center hole back plate.
7. Insert the new LED assembly through the hole where the original bulb and connector were
located. Use caution when feeding the wires through to avoid damaging the wire insulation.
8. Feed the wires through the large hole on the back plate before attaching it onto the back side
of the housing. Flat side of back plate will be on the outside of the tail light housing with the
raised side facing the LED assembly. Make sure to use the special back plate for the small
center hole in the 67 Caprice and align it so the wires come out the top side.
9. Secure the back plate with the supplied #6 screw and lock washer.