Denon AVR-2106 User Manual

Page 37

ENGLISH

Advanced Operation

ENGLISH

FUNCTION REC SELECT

POWER

SPEAKER

Other functions

Playing one source while recording another
(REC OUT mode)

Press the

REC SELECT

button to display the

“RECOUT SOURCE” on the display.

Turn the

FUNCTION

knob to select the source

you wish to record.

For operating instructions, refer to the manual of the
component on which you want to record.
To cancel, turn the FUNCTION knob and select “SOURCE”.

Set the recording mode.

• Recording sources other than digital inputs selected in the REC

OUT mode are also output to the multi source audio output
terminals.

• Digital signals are not output to the REC SOURCE or audio

output terminals.

• The DIGITAL IN’s signal selected with the FUNCTION knob is

output to the DIGITAL OUT (OPTICAL) terminal.

Last function memory

• This unit is equipped with a last function memory which stores

the input and output setting conditions as they were
immediately before the power is switched off.
This function eliminates the need to perform complicated
resettings when the power is switched on.

• The unit is also equipped with a back-up memory. This function

provides approximately one week of memory storage when the
main unit’s POWER switch is off and the power supply cord
disconnected.

Initialization of the microprocessor

If the indication on the display is not normal or if the operation of
the unit is not correct, then the microprocessor should be reset
by the following procedure.

Switch off the unit using the main unit’s

POWER

switch.

Keep both

SPEAKER A

and

buttons depressed

and turn on the unit by pressing the main unit’s

POWER

switch.

Check that the entire display is flashing at 1-
second intervals and release the buttons.

• The microprocessor will be initialized.

• If step 3 does not work, start over from step 1.
• If the microprocessor has been reset, all the button settings are

reset to the default values (the values set upon shipment from
the factory).