Denon AVR-2106 - Manual (Page 12)

9
ENGLISH
Easy Setup and Operation Easy Setup and Operation
ENGLISH
Starting Auto Setup
2 Press the CURSOR D D or H H button to select
“Auto Setup”, then press the ENTER button.
• The “Auto Setup” screen appears.
1
Press the SETUP button.
• The “System Setup” menu appears.
When “S. Back” is selected, the test tone during Auto
Setup will be output from the Surround back speaker.
When “Bi-Amp” is selected, change the setting to “Bi-
Amp”. The test tone during Auto Setup is set so that it will
be output from the Bi-Amp speaker.
3 Press the CURSOR D D or H H button to select
“Power Amp Assign”, then press the CURSOR F F
or G G button to select “S. Back” or “Bi-Amp”.
Measurement of each channel is performed as follows:
4 Press the CURSOR D D or H H button to select
“Start”, then press the CURSOR F F button.
• Start the measurements.
FL FR C SW SL SR SBL SBR
1 2 3
1: Only the front speakers (A) are measured, front
speakers (B) are not available. Even if the front
speakers (B) are set, the setting automatically
switches to the front speakers (A) once
measurements are completed.
2: The subwoofer speaker is measured twice.
3: When “Bi-Amp” is selected, these are not displayed.
After each channel is measured, “Calculating”
appears.
The display switches to the Auto Setup check screen
automatically.
• Measurement is canceled if the MASTER VOLUME control knob
is operated while the Auto Setup is performed.
• If the output volume and crossover frequency of your
subwoofer speaker can be changed, then set the volume to
halfway and the crossover filter to maximum or switch off
the low-pass filter.
2 About automatic retry
To confirm the results of the measurements, remeasurement is
automatically performed.
Remeasurement is performed up to 2 times. During this time,
“Retry1” or “Retry2” is displayed on the screen.
NOTE:
• When measurements have been made using the
measurement microphone, speakers with built-in filters,
such as a subwoofer, might be set to a value that differs
from the physical distance because of the internal electrical
delay.