Vortech 2010+ Camaro Fuel Pump Voltage Booster User Manual

Page 4

DP/N: 007124v1.0

08FEB2010 FPVB UPGRADE

VORTECH FUEL PUMP VOLTAGE BOOSTER

Installation Instructions

2010 CHEVROLET CAMARO SS

Before beginning this installation,

please read through this entire instruction booklet

The Vortech 2010 Camaro Fuel Pump Voltage Booster (FPVB) upgrade was designed

specifically for use on 2010 Chevrolet Camaro SS vehicles equipped with a supercharg-

er to support applications with increased horsepower over the basic kit. As with any

power enhancing product, this unit is intended for use on healthy, well-maintained

engines. Vortech Engineering is not responsible for engine damage. Installation on new

vehicles will not harm or adversely affect the break-in period so long as factory break-in

procedures are followed.
For best performance and continued durability, please take a note of the following key

points:

Use only premium grade fuel 91 octane or higher (R+M/2).

Always listen for any sign of detonation (pinging) and discontinue hard use (no

boost) until problem is resolved.

TOOL & SUPPLY REQUIREMENTS:

• Open End Wrenches (5/16”, 10mm)
• 3/8” Ratchet
• 10mm, 13mm, and 5/16” Sockets
• Flat #2 Screwdriver
• Phillips #2 Screwdriver
• Utility Knife
• Heat Gun
• Soldering Iron/Gun
• Electrical Tape
• Wire Cutters, Strippers and Crimpers
• Drill Motor
• 1/8”, Drill Bit
• Tape Measure