Vortech 1999 & 2001 Ford 4.6L Mustang Cobra - Manual (Page 10)

P/N: 8N020-060
© 2001 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured.
26APR01 V1.0 (4V Maxflow PwrClr(8N020-060).qxd)
2
2. Supercharger Pulley Replacement
Disregard This Section If Installling The Kit For The First Time.
A. Remove original 3.60” supercharger pulley from
the supercharger and install the supplied 3.25” pul-
ley.
B. Mount the supercharger onto the bracket and
reconnect oil feed and drain lines.
C. Reinstall the supercharger and bracket onto the
vehicle.
D. Reinstall the Vortech Accessory Drive Belt.
NOTE: Included in this kit is a smaller than origi-
nally supplied supercharger pulley. This
new pulley is recommended to achieve
best performance results. Removal of the
factory sealed pulley will reduce the
supercharger warranty from three years
to one year unless the supercharger unit
(with the original pulley still attached) and
new pulley are sent into Vortech for
removal, installation and re-sealing. If
supercharger warranty is not a concern
or if the supercharger warranty has
expired, the pulley may simply be
removed and replaced with the new part
supplied. Hammering/prying etc. on the
supercharger and/or pulley will cause
damage to the parts. Light heating of the
supercharger pulley with a propane torch
(if the pulley is tight on the shaft) will aid
removal. A return authorization number is
required before the supercharger and
pulley are sent into Vortech. Call the
Vortech service department at (805) 247-
0226 for return authorization number.
Return freight (ground) will be paid by
Vortech.