Vortech 1988-1992 5.0L/5.7L TPI F-Body - Manual (Page 16)

P/N: 4GF020-010
©2002 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured
12JAN01 V1.1
(88-92 350 TPI Camaro(4GF V1.1))
A. Temporarily install the main bracket on the
engine using two of the 3/8-16 x 5 1/2" bolts as
pilots to position the bracket to the cylinder
head. Remove the fuel line bracket and care-
fully bend the fuel lines as necessary to permit
bracket installation.
B. Install the flat head socket bolt in the chamferred
hole and secure to 32 ft/lb torque.
C. Using the three original fasteners and the one
fastener provided in the kit, secure the power
steering pump to the mounting plate.
D. Loosely attach the supercharger mounting plate
to the new main mounting bracket as shown. It
will be necessary to carefully bend the power
steering pump lines at both the pump and the
steering box to achieve a proper fit so that no
rubbing occurs when the engine moves.
E. Install the alternator between the plate and 2.3"
spacer tube as shown.
F. Fasten the smaller alternator mounting lug to
the supercharger mounting plate with the origi-
nal fastener.
G. Tighten all mounting fasteners.
H. Reinstall the power steering pump pulley to the
pump using an installation tool.
SPACER 'D' -2.3"
SPACER 'C' -4.3"
(2) 3/8-16 x 5-1/2" BOLTS
3/8 -16x1" FLAT HEAD BOLT
SUPERCHARGER
MOUNTING PLATE
(2) 3-8-16x1"
(1) M10-1-1/2" x 30 BOLT
NOTE: BOLTS NOT SPECIFIED ARE ORIGINAL STOCK BOLTS
(6) 3/8 AN WASHERS
(2) 3/8-16 x
5-1/4"BOLTS
POWER
STEERING
PULLEY
POWER
STEERING PUMP
ALTERNATOR
MAIN MOUNTING BRACKET
NOTE: The pulley must be placed on so that
the end of the shaft is flush with the
outer edge pulley boss to assure belt
alignment.
7. MAIN BRACKET AND POWER STEERING PUMP
6