Fuel management unit installation – Vortech 1988-1992 5.0L/5.7L TPI F-Body User Manual

Page 15

P/N: 4GF020-010

12JAN01 V1.1

(88-92 350 TPI Camaro(4GF V1.1))

A. Mount the fuel management unit (FMU) to

the inner fender on the driver's side. Place-
ment should be on the vertical flat area near
the top of the fender above and just rear-
ward of the horn assemblies. Using the
FMU mounting bracket as a template, mark
and drill two 3/32" holes. Use the sheet
metal screws in the kit to secure.

B. It is necessary to plumb the FMU into the

fuel return line. Start by cutting the fuel
return line 7" from the end at the engine.

C. Using the hose splice connect the 14" fuel

line supplied to the 7" length of stock hose
and connect to the FMU inlet.

D. With the second hose splice connect the 12"

fuel line provided to the other end of the cut
fuel line. Connect the other end to the outlet
fitting on the FMU.

E. Connect the 5/32" vacuum line from the

FMU to the intake manifold fitting and se-
cure.

FUEL FEED LINE

FUEL
RETURN
LINE

FUEL TANK

STANDARD

PUMP

FUEL

MANAGEMENT

UNIT (FMU)

ADDITIONAL

FUEL PUMP

ENGINE

CONNECT TO MANIFOLD
VACUUM/PRESSURE

INLET
(FUEL LINE
FROM
STOCK
REGULATOR)

OUTLET

(FUEL FROM

HERE

RETURNS

TO TANK)

NOTE: Make sure you have routed all fuel

lines away from all moving parts,
sharp edges, exhaust pipes and
manifold. Secure the fuel lines with
the tie wraps.

FUEL MANAGEMENT UNIT INSTALLATION