Vortech 1988-1992 5.0L/5.7L TPI F-Body User Manual

Page 14

P/N: 4GF020-010
©2002 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured
12JAN01 V1.1

(88-92 350 TPI Camaro(4GF V1.1))

AUXILIARY FUEL PUMP

A. Open the fuel fill cap briefly to vent any pressure. Find the

stock 3/8" fuel

feed line near the front of the engine's left

valve cover.

B. Cut the stock hose approximately 7" from the fitting nearer

the engine and fit the new hose with the "splice fitting" into
the engine end and secure with a clamp.

C. Place the other end of the new hose on the pump outlet

fitting (brass fitting) and secure with a clamp.

D. Place the fuel pump inlet into the end of the remaining

portion of hose (coming from the tank) and secure with the
provided clamp.

E. Mount the fuel pump to the flat surface ahead of the inner

fender with the hold-down clamp provided as shown in the
graphic.

F. Connect the black wire to the fuel pump and then to a clean

ground and secure.

G. Connect the positive wire first to the pump and then to the

12V terminal at the fuse box using the adapter provided. It

is important that the source is turned on with the key and
remains on during cranking mode. A BLANK fuse will
usually work for this purpose.

H. Make sure the wires are carefully and properly secured.

FUEL RETURN LINE:
CUT STOCK LINES AND SPLICE TO FMU

FUEL FEED LINE:
CUT STOCK LINE AND CONNECT TO
PUMP INLET. USE SPLICE FITTING TO
CONNECT TO ENGINE LINE.

FEED
LINE

RETURN
LINE

CUT, LEAVE 7"