Vortech 1992-1996 5.7L LT1 Corvette - Manual (Page 8)

1994-1996 CORVETTE LTI SUPPLEMENT
HARDWIRING INSTRUCTIONS FOR KITS NOT EQUIPPED
WITH A GM WIRING HARNESS
1. Unplug the grey and black connectors from the coil. Cut the con-
nectors off from the main harness approximately 2" from the end.
2. Attach the supplied male and female connectors to lengthen the
white and pink wires previously cut from the coil connectors. Con-
nect the two pink wires together to one red wire. Attach the pink
and white wires to the red and white wires on the supplied igni-
tion box.
3. Reattach the grey connector to the coil (leave the black connec-
tor disconnected). Using the supplied male and female connec-
tors, attach the pink wire on the grey connector to the orange
wire on the supplied ignition box and attach the white wire to the
black wire on the ignition box.
®
ENGINEERING, INC.
© 1994 VORTECH ® ENGINEERING, INC. all rights reserved
RANE C
ELECTRONICS
HI-6TR
TIMING RETARD CONTROL
R ETARD
VORTECH ® CAPACITIVE DISCHARGE IGNITION
WITH AUTO-SEQUENCE REV LIMITER
*NOTE: CABLE CONTAINS RED AND BLACK LEADS.
MAKE SURE LEADS DO NOT CONTACT EACH
OTHER AND SHORT UNIT WHEN TAPING UP.