Vortech 1992-1996 5.7L LT1 Corvette - Manual (Page 4)

SPECIAL NOTICE CONCERNING THE
Carroll Supercharging
MAF Signal Massager
Some 1996 LT1 Corvettes may require the Carroll
Supercharging MAF Signal Massager to prevent OBD-II trouble
codes from being set. This part is available separately at an
additional cost under P/N: 4GM020-030 direct from Vortech
Engineering, Inc. The MAF Signal Massager, manufactured
by Carroll Supercharging Co., INC., is serviced exclusively by
the manufacturer. Carroll Supercharging Co., INC. warrants
this product to be free from defects in material and workmanship
under normal use and if properly installed for 90 days. In case
of malfunction, this unit will be repaired free of charge according
to the terms of the warranty. If found to be defective as
mentioned above, it will be repaired or replaced if returned
prepaid along with proof of date of purchase. This shall
constitute the sole remedy of the purchaser and the sole liability
of Carroll Supercharging Co., INC. and/or Vortech Engineering,
Incorporated. To the extent permitted by law, the foregoing is
exclusive and in lieu of all other warranties or representations
whether expressed or implied, including any implied warranty
of merchantability or fitness. In no event shall Carroll
Supercharging Co., INC. and/or Vortech Engineering,
Incorporated, be liable for labor charges, special or
consequential damages.
When returning this unit for service, proof of purchase must be
supplied for warranty verification. Please send the unit pre-
paid with proof of purchase to the attention of:
Carroll Supercharging Co., INC.
Customer Service Department
14 Doty Rd.
Haskell, NJ 07420
(973) 835-1705
(973) 835-1660 Fax
www. carrollsupercharging.com
The repaired unit will be returned as soon as possible after
receipt, COD for any charges. Be sure you include a detailed
account of any problems experienced, the type of vehicle and
any modifications.
Should you have any technical or installation questions
regarding this unit, contact Vortech Engineering,
Incorporated, directly at (805) 247-0226, M-F 8AM-4:30PM
(PST).
®
ENGINEERING, INC.