Vortech 1992-1996 5.7L LT1 Corvette User Manual
Page 19

BRACKET
HEADLIGHT
WELL
AIR FILTER TUBE
RUBBER ELBOW
AIR INLET DUCT
RIGHT
FRONT
TIRE
TOP VIEW
FRONT
VIEW FROM
BOTTOM
RIGHT
FRONT
TIRE
9
8A. AIR INLET (1992-1993 Models)
A. Trim the fiberglass splash guard as shown in the
graphic.
B. Install the air filter mounting tube and bracket into
the right side front headlight well (ahead of the
wheel) where the coolant reservoir was originally
located. Use the original holes and bolts to secure
the bracket.
C. Install the rubber 90
°
elbow with a #200-84 band
clamp onto the air inlet on the engine compartment
side.
D. Use a #40 clamp to attach the filter tube to the
mounting bracket. Install the 3-1/2" sleeve and
#56 clamps, attaching one of the clamps to the
bracket as shown.
E. Install the air filter extension and clamp onto the air
inlet tube inside of the right side headlight pocket
(1992-1993 models only). Attach air filter.
8B. AIR INLET (1994-1996 Models)
A. Follow steps 8A-D above.
B. Locate the MAF sensor connector in the vehicle
wiring harness and cut all three wires approxi-
mately 2" away from the connector.
C. Extend the MAF connector by using the supplied
36" wires and shrink sleeve. Soldering is recom-
mended. Crimp connectors have been supplied
for applications where soldering is not possible.
D. Attach the MAF meter to the air filter tube as
shown. Route the MAF connector down into the
headlight well and attach to the air meter. 3/8" flex
loom has been provided to protect the extended
harness. Attach the supplied air filter to the air
meter inlet.
NOTE: Double check the wire to wire (MAF
and harness) relationship before soldering
and sealing.
#40 CLAMP
#56 CLAMPS
AIR FILTER
TUBE BRACKET
1992-1993
AIR FILTER
EXTENSION
1994-1995
MAF METER
OR
_
3-1/2" X 2" SLEEVE