Vortech 2004 Pontiac GTO - Manual (Page 14)

6
P/N: 4GJ020-010
©2004 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured
28SEP04 v1.0 GTO(4GJ020-010v1.0)
Fig. 4-a
4. OIL FEED
A. Remove the oil filter.
B. Remove the 6mm nuts holding the small cast-
plate located directly above the oil filter. (Set
aside the plate and gasket for later use)
C. Double nut each of the studs and remove
them.
D. Using engine oil on the threads, install the
1/8NPT to –4 90° fitting into the supplied oil
feed adapter.
E. Using the adapter, the supplied factory gasket
and the supplied longer 6mm screws, assem-
ble the components as shown in Fig 4-a.
F. Orient the installed fitting so that it is pointing
away from the engine.
G. Install the oil feed hose onto the open -4 end
of the fitting. Route the oil feed hose so that it
follows the side of the alternator up to the
supercharger mounting location.
ADAPTER BLOCK
1/8NPT TO -4 x 90° FITTING