Vortech 2004 Pontiac GTO - Manual (Page 12)

4
P/N: 4GJ020-010
©2004 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured
28SEP04 v1.0 GTO(4GJ020-010v1.0)
3. COOLANT RESERVOIR MODIFICATIONS
A. Install the supplied coolant reservoir bracket,
containing the factory bumper and grommet
stud, in the same location as the factory
bracket.
B. Remove the grommet stud from the inside
drivers fender wall.
C. Locate the supplied 1" aluminum spacer.
Thread the supplied 6mm stud into one end
half way into the spacer. Thread the grommet
stud into the open end.
D. Thread the spacer, stud and grommet stud
assembly into the factory mounting location.
(See Fig 3-b.)
E. Remove the Ø1" hose from the bottom of the
coolant reservoir. Use the supplied Ø1.0 x
4.0" piece of hose, #16 hose clamps and
Ø1.0 hose mender to lengthen the hose. (See
Fig 3-c.)
F. Modify the computer heat shield as shown in
Fig. 3-d and reinstall it back in the factory
position. (See Fig 3-e.)
Fig. 3-a
Fig. 3-b
Fig. 3-c
NOTE: The brackets will appear the same, but on the
supplied bracket the tabs are bent 180° from
stock. (See Fig 3-a.)
SUPPLIED SPACER WITH GROMMET STUD
SUPPLIED Ø1" x 4" HOSE