Tiptop Trigger Riot - Manual (Page 19)

Set Loop End:
- Press End/B4 until ‘LPEd’ displays
- Press Bank and then Preset to select the loop end
- Press Bank and then Preset to select the loop end
Note: Loop End points can be before the Start point to reverse the direction of the
loop.
SyncBus:
The SyncBus is a unique synchronization standard that we have developed for syn-
chronizing our sequencers with amazing timing and intelligence. The SyncBus uses
high speed parallel data communication to achieve this and is the recommended
method for synchronizing multiple Trigger Riots. Multiple devices are connected
using a special ribbon cable on the back of the module. This connection carries
clock, reset, preset and a ‘Boss’ signal to determine which device is the master.
Firmware version 1r04 introduced a sync mode called ‘Cr’ that makes sync between
the Riot and Circadian Rhythms easier by ignoring the changing presets on the CR.
The Riot will continue to use its internal CYCS/CYCE and Preset Loops in this
mode.
Connection Diagram:
back view
SyncBus Cable SyncBus Cable
*More Trigger Riots can be connected, example
shows 3 for clarity.
19