Taser X26 - Manual (Page 17)

TASER® CDPM Operating Manual • MMU0014 Rev: B 17
9. Insert a standard DPM, software revision 22 or greater, in the X26 device. Verify that the
DPM release button pops out from the recess position with an audible click.
Note: You can use the CDPM instead of a standard DPM. In this instance, the X26 device will be
programmed to revision 22 or greater. Additionally, if you use the CDPM after the device has been de-
configured, the lanyard/wrist strap will still act to disable the X26 device; however, the security code
feature will not be enabled. In this case, by simply reattaching the lanyard/wrist strap, the X26 device
will be fully operational again without the required 5-digit activation code.
10. A “P” is displayed on the X26 device CID for about 6 seconds, indicating that the X26 device
operational code is being programmed into the device. When programming is complete, the
DPM insertion boot up sequence will display.