Taser X26 User Manual
Page 14
14
TASER® CDPM Operating Manual •
MMU0014 Rev: B
13. Enter the 5-digit activation code. Use the same process as steps 8–9.h.
• A non-blinking “AC” on the LED display indicates that the
5-digit activation code has been accepted and validated
(Figure 16). Go to step 14.
• A non-blinking “AF” on the LED display indicates that
the activation code entered is not correct (Figure 17).
If this occurs, repeat steps 8-9.h to re-enter the activation code.
14. Place the safety switch in the down (SAFE) position. The X26 device is now
configured and ready for use when the safety switch is placed in the up (ARMED)
position.
Note: By simply installing a CDPM without first configuring the device with the
green CCDPM, the lanyard/wrist strap will still act to disable the X26 device; however,
the security code feature will not be enabled. In this case, by simply reattaching the
lanyard/wrist strap, the X26 device will be fully operational again without the
required 5-digit activation code.
Figure 16
Figure 17