beautypg.com

Finish setting up your avr or pre/pro, Task, Sv sound, llc – SVS AS EQ1 User Manual

Page 32

background image

AS-EQ1 Operator Manual

© 2009 SV Sound, LLC

6420 Belmont Avenue, Girard, OHIO

703.845.1472

www.svsound.com

SV Sound, LLC

TASK:

Finish Setting Up your AVR or Pre/Pro

If your AVR or Pre/Pro IS equipped with Audyssey MultEQ:

Remove the SAT Output connection from your AVR or Pre/Pro, and ensure your AVR or Pre/Pro’s

Subwoofer Pre-Out is attached to the appropriate Input of the AS-EQ1. Following the instructions

provided with your AVR or Pre/Pro, and with your AVR or Pre/Pro’s Mic attached to the AVR or Pre/Pro

(NOT the AS-EQ1) perform the MultEQ setup and calibration. The AS-EQ1 should be powered on, enabled

and in the signal path, and your Subwoofer(s) on and set from the AS-EQ1 calibration.

After finishing your MultEQ setup and calibration on your AVR or Pre/Pro, check the subwoofer trim

level in your AVR or Pre/Pro set-up menu. If your Sub trim is between -3.5 dB and +3.5 dB your AS-EQ1 is

now successfully integrated into your audio system. If the subwoofer trim level falls outside the range of

+/- 3.5 dB, please contact SVS ([email protected]) to determine if additional action is necessary.

Remove the SAT Output connection from your AVR or Pre/Pro, and ensure your AVR or Pre/Pro’s Subwoofer

Pre-Out is attached to the appropriate Input of the AS-EQ1. Using your AVR or Pre/Pro’s Setup menu, enter

the Distance and Trim level for your subwoofer(s) given in the Detection Results screen. If your Sub trim

is between -3.5 dB and +3.5 dB your AS-EQ1 is now successfully integrated into your audio system. If

the subwoofer trim level falls outside the range of +/- 3.5 dB, please contact SVS ([email protected]) to

determine if additional action is necessary.

If your AVR or Pre/Pro is NOT equipped with Audyssey MultEQ:

Calibrating the AS-EQ1 in Your Listening Environment

32