StorCase Technology 14-Bay 4U SCSI Ultra320 - Manual (Page 29)

20 InfoStation User Interface
StorCase Technology, Inc. InfoStation 14-Bay U320 User's Guide - Rev. A00
1. Press ENTER at the Default Display so that
display = Status.
2. Press DOWN until display = SAFT Cfg.
3. Press ENTER so that display = SCSI ID.
4. Press DOWN so that display = MultiLUN.
5. Press ENTER so that display = MulLUN=x.
This is the current MultiLUN setting.
6. Press UP or DOWN to change the MultiLUN
setting.
7. Press ENTER to accept the change.
ENTER
S t a t u s
T E M P : x x C
S A F T C f g
DOWN
S C S I I D
M u l L U N = 1
ENTER
UP/DOWN
M u l t i L U N
M u l L U N = 0
ENTER
DOWN
M u l L U N = 0
ENTER
SAF-TE Processor Board Multiple LUN Set-Up
The following steps show how to change the SAF-TE processor board Multiple LUN set-up.
The Multiple LUN feature is only supported by the StorCase RAID Controller. Change the setting
(to Single LUN) when using the optional SAF-TE board in conjunction with a non-StorCase RAID
Controller (such as a PCI-based controller).
NOTES: Only necessary if the optional SAF-TE board is installed and used in con-
junction with a non-StorCase RAID Controller.
MulLUN 0 = Single LUN
MulLUN 1 = Multiple LUN (Factory Default)
Press CANCEL at anytime to exit the menu system and return to the Default
Display.The menu system will automatically cancel after 15 seconds of
User inactivity.