Rear panel – StorCase Technology 14-Bay 4U SCSI Ultra320 User Manual

Page 15

Introduction

StorCase Technology, Inc.

InfoStation 14-Bay U320 User's Guide - Rev. A00

Rear Panel

(Figure 3)

I/O Repeater Module(s) - InfoStation comes equipped with either one, two, or four

Ultra320 repeater modules. Additional I/O repeater modules are available, for up to

four (4) channels. Refer to Appendix B for further information.

NOTE:

For SCSI Ultra320 operation, the InfoStation requires Ultra320 drives,

Ultra320 HBA, Ultra320-compliant cabling (internal and external), and

Ultra320 repeater modules installed.

I/O Repeater Module LED(s) -

Error LED (Amber) -

Flashing indicates a detection in either:

1. Over temperature

2. Low termination voltage

3. Invalid differential voltage

Activity LED (Green) -

ON indicates activity is present.

OFF indicates there is no activity present.

Refer to the UIM or InfoMon for detailed information on I/O repeater module status.

I/O Blank Plate(s) - May be removed when installing additional I/O repeater modules.

NOTE:

Blank plate (provided) must be installed if any module slot is left

empty. Installation of the blank plate is necessary for proper

cooling inside chassis.

Blower Module(s) - Depending on the model, either single or dual redundant, hot

swappable modules each with two (2) high-pressure blowers inside, provide ample

cooling for high speed drives (79 CFM each module). Each module features blower

fault detection, total usage hours, and self-adjusting blowers for optimal cooling

performance.

Blower Module LED(s) -

Green LED -

Steady glow indicates normal blower operation.

Red LED -

Flashing indicates at least one blower failure.

Module Handle(s) - Provide a sturdy grip for the installation and removal of the

InfoStation modules.

WARNING:

DO NOT USE MODULE HANDLES TO LIFT CHASSIS! These

handles are specifically designed for the installation and re-

moval of modules only!